Point of Sale

This item describes the setup for the MPAD (KVM / KVD / Kitchen Video Display / Kitchen Video Monitor)

Required Files  
                              AFJ_MPAD.EXE
                              AFJ_MPAD.DAT
                              AFJ_MPAD.TST
                              AUTOEXEC.BAT  

You Will need to Download them to your MPAD using Hyperterminal. (Null Modem Cable)
Set Up
-Direct Using COM 'X'
-57600 Baud
-8 Bits
-NO Parity
-1 Stop Bit
-Hardware Flow Control
-X Modem Protocal


To do this Boot the MPAD and press the "R" key as it boots.
It will request the file name..... You must enter D: and the file name (Files are received to the D drive)
At the Hyperterminal end send the corresponding file.   (X-Modem Protocol)
When All files have been transfered press the ENTER key in response to the File Name Prompt.
This will bring you to the C:> prompt.
Now copy the four files from the D: to th C: ............. Copy D:*.*
4 files should be copied.
reboot and test.

Setup after (and including) version 3.6.4 

Run the order processor as a printer instead of a bump bar. Set the type of the printer to MPAD. You will also need to edit C:\Program Files\Fedelta\FedeltaPOS\config\prefs\afj\fedelta\device\printer\user.pref to setup the com port (if not using COM1) manually. Example:

comPort1=COM5
comPort2=COM6 

Woud be appeded to the files contents if Printer1 and Printer2 where MPAD kitchen displays running on COM 5 and 6 respectivly. Note: The number after "comPort" identifies which printer this setting is for. Make sure this lines up to how you have specified any printers in the Preference Editor. Also the equivalent settings are available on the server if the server is required to run this type of "printer".

Setup Before version 3.6.4

To setup Fedelta to communicate with the Kitchen Video Display you need to do 2 steps:

1. Setup an Product-> Order Processor from the Backoffice taking note of the name (needed for next step)

2. You need to provide a preference with the name of the order processor with “_port” (without quotes) appended; followed by e.g. = COM3             

   i) Edit C:\Program Files\Fedelta\FedeltaServer\config\prefs\afj\device\orderdisplay\system.pref
   ii). Add e.g. "KVD1_port = COM3" (without quotes assuming you created an order processor named KVD1)
   iii) Add e.g. "KVD2_port = COM4 " (without quotes assuming you created a second order processor named KVD2)

Restart the Fedelta Server.